The Streak F4 v3 represents the next generation of FPV racing flight controllers with a clock speed of 168Mhz using the STM32F405 32-bit processor.  Coupled to the powerful MCU vis a 75Mhz SPI bus is the ICM-20608-G IMU sensor which provides sensor updates to the MCU as fast as the MPU can go.  The looptimes of this flight controller within raceflight are so fast you almost dont need to care about PID tuning allowing you to simply drop this into your racing quadcopter and go fly knowing you will have decent response especially when using blheli ESC.  So if you are looking for the ultimate performance from your flight controller for FPV racing the Streak F4 will deliver.  The integrated PDB and voltage regulator supports 2-6S lipos, with a solder point for an XT60 connector

If that was not enough the streak F4 V3 now also include a built in betaflight OSD module and current sensor, making this the ideal FPV racing flight controller.  You can think of the Streak F4 as a FC+PDB+OSD+Current sensor in one!

This flight controller is also stackable with our cicada 4in1 ESC, but also has a built in PDB capable of 200A current so you can still use individual ESC's for your racing quadcopter.

When updating firmware please select the target to be OMNIBUS.

Key Features of Streak F4 v3

• Supports raceflight and betaflight firmware, default is betaflight, very easy to re flash.
• Built in OSD
• Built in Current sensor
• Compatible with both SBUS and PPM receivers (PPM when flashed with raceflight as it is not yet supported in Betaflight)
• ICM-20608-G Accelerometers and Gyros connected via 75Mhz SPI bus
• Bult in PDB capable of up to 200A, 2-6S Lipo support
• Integrated 5V and 12V voltage regulator to power other electronics or FPV gear
• Gyro and MCU have 3.3V independent power supply
• Supports up to 6 motor outputs (ESCs) (6 x 3 pin through hole pins)
• Built in SBUS inverter
• Powered by STM32F405 32-bit processor at 168MHz, 1Mb flash, 192kb ram
• Micro USB connectivity using STM Virtual Communications Port
• M25P16 16 Mbit, serial Flash memory, 75 MHz SPI bus interface 
• 35mmx35mm board, standard 30.5mm mounting holes for stacking.
• Weight 10.8g