LITEBEE 8CH PPM Encoder with Case for Pixhawk APM PPZ MK MWC MegaPirate Flight Controller

The PPM Encoder plugs into the PWM servo output ports of any R/C receiver and encodes them into a PPM pulse suitable for many autopilots(e.g.Pixhawk and APM). Modifications to the R/C receiver are not necessary.

The whole project is based around the ATMEL ATMEGA328p AVR processor and all timing is done within interrupts so accuracy and stability is optimized.

The design of the PPM Encoder is based on the Paperazzi PPM Encoder.

The jumper on the board no soldering default. In this case the board powered by FC.

Dimension: 28* 19* 5mm/1.1* 0.74* 0.2in(approx); Weight: 9g(include all wire)

Manual:http://copter.ardupilot.cn/wiki/common-ppm-encoder/

Important Note:
The firmware comes pre-configured to read 8 Channels.
In case you would like to change the settings of the PPM encoder to invert the PPM signal
and change the fail safe pre-defined values you will need an AVR ISP programmer in order to reprogram it.

Size and weight:
Dimension: 28* 19* 5 (mm) /1.1* 0.74* 0.2in (approx)
Weight: 9g (include all wire)
----------------------------------------------------------------------------------------------------
Package Including
1 * PPM Encoder
1 * 10Pin input cable 60mm
1 * 4Pin output cable 100mm