Matek F722-SE AIO Flight Controller

Matek F722-SE AIO Flight Controller

The new all in one F7 based flight controller from Matek featuring a dual IMU and dual camera input support. Also a VTX on/off power switch making this FC stand out form the rest.  The F722-SE has a powerful STM32 F7 MCU running at 216Mhz to get the best measurements from its dual IMU giving you the stable and vibration tolerant readings from the MPU6000 gyro. The duel chip also now means you can run ultra fast 32Khz update rate from the ICM20602.  The F722 also inlcudes a BMP280 pressure sensor and the usual betaflight OSD chip. Blabkbox logging as standard is done via the MicroSD card slot.

FC Specifications

• MCU: 216MHz STM32F722RET6
• IMU: MPU6000 & ICM20602, Dual Gyros built-in (SPI)
• Baro: BMP280 (I2C)
• OSD: AT7456E (SPI)
• Blackbox: MicroSD card slot (SPI)
• 5x Uarts (1,2,3,4,6) with build-in inversion
• 1x Softserial supported
• 8x Dshot/Proshot/oneshot outputs
• 1x I2C
• 4x RX6 pad(one per cornet) for BLheli32 ESC telemetry
• 4x individual ESC power/signal pads
• 1x Group of  G/S1/S2/S3/S4 pads for 4in1 ESC Signal/GND
• 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red)
• Vbat filtered output power for VTX,  Switchable via AUX (modes tab-user1)
• Dual Camera image switchable via AUX (modes tab-user2)
• Camera control: Yes
• Smartaudio & Tramp VTX protocol: Yes
• WS2812 Led Strip : Yes
• Beeper : Yes
• RSSI: Yes
• Additional ADC for INAV analog airspeed

PDB Specifications

• Input: 6~36V (3~8S LiPo) w/TVS protection
• PDB: 4x35A (Max.4x46A)
• BEC: 5V 2A cont. (Max.3A)
• LDO 3.3V: Max.200mA
• Current Sensor 184A (Scale 179)
• Battery Voltage Sensor: 1:10 (Scale 110)

FC Firmware

• BetaFlight / INAV
• Target: MATEKF722SE

Physical

• Mounting: 30.5 x 30.5mm, Φ4mm with Grommets Φ3mm
• Dimensions:  36 x 46 mm
• Weight: 10g

Including

• 1x FC F722-SE
• 6x silicon grommets M4 to M3
• 1x FR4 PCB Plate 36*36*1mm
• 1x Rubycon ZLH 35V/470uF (Low ESR)

CLI Settings

General 4 x ESC wiring

Wiring to a 4in1 ESC