Crazybee F3 Pro Flight Controller for 2S Brushless Whoop (Mobula7)

The crazybee F3 pro is the ultimate brushless whoop flight controller.  It is a 2S compatible betaflight control board with integrated 5A Dshot ESC's, integrated OSD and Receiver.  So if you are looking to build your next brushless whoop this flight controller should be at the heart of it.  It is also the flight controller used on the popular mobula7.

Specifications

Flight Controller

• CRAZYBEEF3 PRO FS Firmware target: CrazybeeF3FS
• MCU: STM32F303CCT6 (72MHZ, 256K FLASH)
• Sensor: MPU-6000(SPI connection)
• Board size: 28.5 * 28.5MM
• Weight:4.2g
• Power supply: 1-2S battery input (DC 3.5-8.7V)
• Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
• Built-in SPI Flysky receiver with telemetry(D8/D16 switchable)
• Built-in Betaflight OSD(SPI Control)
• Built-in Current meter Max 28A
• Current meter scale set to 1175
• Built-in 5V 1A Buck / Boost with LC filter
• Built-in voltage detection
• BLHELI_S pass-through Ready
• Heading LED Ready

Integrated 4in1 ESC

• MCU upgraded to EFM8BB21
• Power supply: 1-2S LiPo/LiPo HV (3.5v/8.7v)
• Current: 5A continuous peak 6A (3 seconds)
• Support BLHeliSuite programmable
• Factory firmware: S_H_50_REV16_7.Hex
• Default protocol: DSHOT600

Integrated Receiver (Flysky version)

• SPI BUS receiver
• Protocol: AFHDS and AFHDS-2A Switchable
• Channels: 8ch(AFHDS) or 14ch(AFHDS-2A)
• No ground interference ( Transmitter and receiver 1 m from the ground): 300m
• Failsafe support

Integrated Receiver (FRsky version)

• SPI BUS receiver
• Frsky D8/D16 switchable
• Compatible Non EU transmitter both D8 and D16 mode
• Channels: 8ch or 16ch
• Failsafe support
• No ground interference ( Transmitter and receiver 1 m from the ground): 300m