Beecore BL F3 1S Brushless Whoop Flight Control

The Beecore BL is a 1S compatible brushless flight controller to power your Tiny Whoop.  It features an omnibus F3 flight controller complete the betaflight OSD support.  It also has an integrated Dshot compatible 5A 4in1 ESC to power your brushless motors (0603 or 0802) motors.  All this fits into the standard tiny whoop form factor to make this FC the go to choise for indoor quads.

Specifications

Flight Controller

• Firmware: betaflight_3.2.1_OMNIBUS
• CPU: STM32F303CCT6 (72MHZ, 256K FLASH)
• Sensor: MPU-6000 triaxial accelerometer / triaxial gyroscope (SPI connection)
• Power supply: 1S Lipo / LIHV battery input (DC 3.6-4.35V)
• BEC: Built-in 5V / 0.5A step-up circuit
• Compatible Receivers signal: PPM, SBUS, IBUS, Spektrum DSM2 / DSMX, 1024/2048.
• Built-in OSD interface
• Active buzzer interface
• Dshot ESC ready
• Blheli_S pass-through ready
• Built-in voltage detection, alarm
• Board size: 29MM * 29MM
• Screw hole spacing: 36 * 36MM diameter 3.0MM
• Board weight: 3.2 g
• 4x JST1.25mm 3pin plug soldered

ESC

• Power supply: 1S Lipo/LiHV battery
• Current: 5A continuous peak 6A (3 seconds)
• Support BLHeliSuite programmable
• BLHELI_S Firmware target: O_L_5_REV16_6.HEX
• Signal Support: D-shot150, D-shot300, D-shot600, Oneshot125, Multishot, PWM”