KISS 32bit ESC 2-5S 25A 4in1 (40A limit)

KISS 32bit ESC 2-5S 25A 4in1 (40A limit) as used by Mr Steele

The KISS ESC25A 4in1 is simply connected to the FC with a cable and can then be installed in the stack under or over the FC. All you have to do is solder the 4 x 3 motor cables and the voltage supply from the Lipo.

With a maximum short-term current output of up to 160A (4 x 40A), sufficient reserves of power are available for future motors.

As usual, the controller transmits all important telemetry data such as voltage, current, temperature or speed via the TLM line. These can then be displayed via an OSD or in the remote control.

When a world renowned pilot like Mr Steele uses Kiss then you know its good. 

SPEC

32-Bit-ARM Cortex M4 MCU @ 80 MHz

Telemetry capability (voltage, current, temperature, rpm)

Over current protection (measures the current and reduces it to max 40A)

Over temperature protection (reduces the max power if hotter then 100°C)

sinHybrid :: Sinwave/BackEMF Hybrid Commutation for smoother running.)

Dshot 2400 (Full resolution of 2000 steps takes only 6.5μs).

Supports all common Dshot commands like turtle mode, 3D mode and rotation direction change.

Expanded adaptive auto timing (7.5-30° advance on each commutation),

For Race Multicopters (25A continuous also with weak cooling),High max. RPM (500.000ERpm, 71.400Rpm with a 14Pole Motor) 

Small size (37.5 x 42.5 mm) 3cm hole distance with 3,4mm size to stay full compatible

Accurate RPM control (2000 steps using Dshot)

No additional capacitor needed for 3-5S.

Very fast throttle response, Linear throttle response, Active freewheeling (low diode losses)

Regenerative braking

100-2400, Oneshot42, Oneshot125 and (25 - 500 Hz) PWM get autodetected.

Supports FrSky Sbus, Graupner SumD, TBS CROSSFIRE and Multiplex SRXL, S-Port, Graupner HOTT, TBS CROSSFIRE and Sensorbus

Operating voltage 6 - 24V (2-5s)

Maximum continuous current 25A, instantaneous maximum current 40A, actively limited

600000 ERPM maximum rotation field speed (usage up to 500000 recommended)

6 Layer 70µm copper PCB where almost all of the layers can be used for the current as the logic parts sits on a separate PCB

All in and outputs are protected against over (~30V) and undervoltage(~-30V) but are still 3,3 and 5V compatible

Modern smart gate driver.

1980µF 25V ceramic capacitors onboard

Connection Cable for KISS FC (not included in the package)