Matek PDB-HEX PDB

Overview:

The Matek PDB-HEX power distribution board features a 140A current sensor and 5V & 12V/9V filtered DC voltage output. This PDB is perfect for hexacopters as it has 6 esc power/signal and telemetry pads.

Features:

Input voltage range: 6~60V (2~12S LiPo)
PDB/current sense resistor: 140A cont, 264A burst.
ESC power pads: 60A cont. 100A burst
6x ESC power /signal/ telemetry pads
Current Senor: 264A, 3.3V ADC
Current Scale 125(INAV/BF), BATT_AMP_PERVLT 80 (ArduPilot)

JST-SH-8P Connector and Pads
Vbat: Battery voltage
G: ground
Curr: current signal
Tlm: Duplicates Tlm pads for ESC telemetry
S1/S2/S3/S4/S5/S6: ESC signal
Vx: Regulator output

BEC Vx output (5V default)
Vx= 5V by default, Continuous 5 Amps
Bridge 9V jumper, Vx= 9V, Continuous 4 Amps, Max.5A
Bridge 12V jumper, Vx= 12V, Continuous 4 Amps, Max.5A
Output Short-circuit tolerant (1 seconds)
Overcurrent protection & self-recovery

Voltage divider
1K:20K resistors
Output 1/21 Vbat voltage

Physical
Mounting: 30.5 x 30.5mm, 20 x 20mm, Φ3mm
Dimensions: 49 x 40 x 6 mm
Weight: 12g

Included:

1x Matek PDB-HEX
1x Rubycon ZLJ 63V 390uF
1x JST-SH1.0_8pin cable, 5cm
2x JST-SH1.0_8pin connectors