Micro OSD Compatible with Pixhawk

The Micro OSD, is a refined version of the popular Minim OSD for Arducopter FCs. It uses the Max7456 chip powered by two stages to avoid noise and provides an extra clean power line feed to the FPV camera and video link. It's also smaller and comes in a hard case.

As with the Minim Osd, the Micro OSD adds a telemetry overlay to your FPV video feed, so you can view status information such as flight mode, altitude, speed, heading and lots more in real-time. The alternative method to view telemetry data is to use the 433MHz telemetry module with a laptop and run the Mission Planner ground control software. The OSD is wired between your FPV camera and FC and works by reading the MAVlink message from the telemetry port found on flight controllers such as the APM and Pixhawk.

The OSD is preconfigured for use with Arducopter flight controllers and it includes pre-wired leads.

Important Note: You cannot connect the OSD when your APM 2 is also connected via USB (they share the same port). Make sure you disconnect your USB cable from the FC board before attempting to use the OSD.