Matek Systems HUBOSD8-SE w/STOSD8-SE, Current Sensor, Dual BEC and 6S Max

The Matek HUBOSD8-SE is a fully featured well designed PDB for FPV racing drones. It is a multifunctional HUB with 4 channel PDB, dual BECs, a current sensor and a plug and play integrated OSD.

The PDB can provide power up to four ESCs rated at 30A per channel and compatible with 3 to 6S LiPo batteries. The BEC outputs provide 5volts at 1.5A and 10volts at 1.5A, while the built-in current sensor measures up to 184A. Note that the 10V output can be used to power 12V cameras.

The new, built-in STOSD8-SE (OSD) is integrated into the PDB and therefore super easy to use as it doesn't rely on a connection to you FC; it's totally independent. It supports lots of functions including auto battery cell detection, low voltage alarm, current draw, automatic flight timer, onscreen pilot ID and more. The OSD function can be used without any programming, but if you wish to change any of the default settings or enable functions for example the pilot ID, there is a very simple GUI - download here (you will need a FTDI USB programmer).

The PDB is well designed with corner mounted ESC power connections for a neat installation and easy to solder power input.

Features:

• Built-in STOSD8-SE - plug and play OSD
• Current sensor 184A max
• 2oz copper, 4-layers & 2mm PCB
• 1x Battery input, 4x ESC outputs. 2x BEC 5V outputs, 2x BEC 10V outputs
• Camera signal and ground pads, video transmitter signal and ground pads
• 1x Serial port (RX, TX, G)
• RSSI input pad and current sensor output pad

STOSD8 

• Autodetect PAL/NTSC - Auto sense PAL / NTSC cam at OSD startup.
• Dynamic on screen info - Basic info for flight. More info after landing.
• Automatic flight timer - Trigger but a current >2A.
• Automatic cell detection - STOSD detects the cell numbers automatically when the LiPo is connected.
• Low voltage alarm - Auto battery alarm blinks the battery voltage when pack voltage hits the low limit.
• Exceeding mAh alarm - Auto capacity alarm blinks the mAh when capacity exceed the setting. Default is 1000mAh.
• Min.voltage & Max.current recorder - Current less than 2A & keep 5 seconds. Min.Voltage & Max.current will be shown on screen.
• Onscreen Pilot ID - Default Pilot ID is disable. you can enable it in GUI.
• Firmware upgradable - Firmware upgradable to ensure any user can enjoy any new features that we might release the future.
• Plug & Play - You can use it with default firmware & settings. No PC connection needed if you don’t want to change the settings.
• Simple GUI - No complicated settings.

STOSD8 Tool & STOSD8-SE updates

Thread & Discussion on RCGroups

Bench Test Demo 4S / 6S