Matek F405-STD F4 Betaflight Flight Controller with OSD and Baro

FLIGHT CONTROLLER F405-STD

Features:

• F405 MCU with ICM20602 32Khz gyro
• F405 supports PID loops at 16Khz
• Betaflight OSD
• 6x PWM / DShot outputs without conflict
• 5x UARTs
• 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
• 1x Group of G/S1/S2/S3/S4 pads for 4in1 ESC Sginal/GND
• 4x pairs of corner pads for ESC Signal/GND connections (DSHOT compatible)
• 2x 2812 LED outputs for loads of RGB bling
• 1x pair I2C1 pads for use with a magnetometer (iNav)
• 1x Side-press button for BOOT(DFU) mode
• 1x 16pin bottom mounted FFC Slot for FCHUB-6S, FCHUB-VTX or FCHUB-W connection
• 4x M3 Anti-vibration Standoffs

Note: Please always test the board first using usb connection as returns cannot be accepted once the FC as been soldered.

Recommended PDBs:

Matek FCHUB-6S

or

NEW Matek FCHUB-VTX - Like the FCHUB but with a built in VTX!

General Spec:

Drivers & Softwares

• Zadig 2.3
• STM32 Virtual Com Port driver
• STM Flash Loader Demonstrator
• STM DeFuse Demo v3.05

BetaFlight Github

• BetaFlight GitHub
• BetaFlight FW Releases
• BF lastest build  https://ci.betaflight.tech/

BetaFlight Firmware

• Betaflight_3.2.3_MATEKF405
• Betaflight_3.2.4_MATEKF405
• Betaflight_3.2.5_MATEKF405
• Betaflight_3.3.0_MATEKF405

INavFlight Github

• iNavFlight GitHub
• iNavFlight FW Releases

INAV Firmware

• inav_1.8.0_MATEKF405
• inav_1.9.0_MATEKF405  INAV official release
• inav_1.9.0_MATEKF405-Softserial  Customized firmware. Softserial1_TX on TX4 pad for Frsky Smartport

Tips:

• CLI “defaults” after reflashing.
• Rubber anti-vibration standoffs are necessary to avoid vibration related issues.
• If you are using 5V VTX, Pls power the VTX via the 5V pad on FCHUB.  The ribbon cable can’t bear heavy current.
• 2812LED_Strip share I2C1_SCL pad as default.  either enable LED_Strip, or enable Baro.
• 2812LED can be resourced to S7 (PB8) if using Baro the same time with BF firmware
• Put a piece of sponge on the barometer to reduce the impact of airflow.