LITEBEE Matek PDB OSD, Power Distribution Board (OSD, PDB 4*30A, Input 3S - 6S, BEC 5V&10V, 184A Current Sensor) for FPV Racing RC Drone Quadcopter by

PDB --- Continuous current:30A per output, Peak current ( 5 seconds/minute ): 46A per output

DUAL BEC ---BEC 5V output:Desognded for RC Receivers, flight controllers,OSD. BEC 10V outputs: Designed for Vieo TX or FPV camera. 10V can be used to power camera labeled as 12V. The 3S Lipo input voltage should be 10.8V plus.

Current Sensor --- 184A Max. Current signal output: 3.3V ADC for Flight controller.

STOSD8-SE ---Running indicator,Autodetect PAL/NTSC, Dynamic on screen info,Min.Volt Max.Amp recorder. Automatic flight timeer. Auto battery cells detection. Onsceen pilot ID. Firmware upgradeable

For most Racing flight controller --- Naze32, F3, F4, Kiss, LUX Seriously Dodo Flight Controller and so on. For almost motor --- such as 2204 2300, 2205 2600,2205 2300, 1306 3300 4000,1806 2280. For FPV RC Racing Drone --- QAV R QAV X ZMR 250 220 210 230 180 and so on

Tips: If current signal pad is connected to FC, the CURRENT METER must be ON in FC GU
Some helpful link:
MANUAL:http://www.mateksys.com/downloads/HUBOSD8-SE_EN.pdf
Details about STOSD: http://www.stosd.com

-current sensor 184A
Built-in transient voltage suppressor

-Serial port
RSSI(PWM) input
Current signal output

Specification:
Brand: Matek Systems
Input: 9-27V(3-6s Lipo)
Input TVS protection
PDB: 4 X 30A( Max.4x46A)
BEC 5V 1.5A(2A Max.)
BEC 10V 1.5A(2A Max.)
Current Sensor 184A
Built-in STOSD8-SE
Size: 46x36x4mm
Mounting holes: 30.5mmΦ3mm
Weight: 9g

-STOSD8-SE
Autodetect PAL/NTSC
Dynamic on screen info
Automatic flight timer
Auto battery cells defection
Low battery alarm
Exceeding battery alarm
Min.voltage & Max.current recorder
Onscreen Pilot ID
Firmware upgradable
Simple GUI & setting
Plug & Play
BEC power indicators(Red)
STOSD indicator(Blue)
-----------------------------------------------------------------------
Package included:
1 * PDB
1 * Rubycon ZLH
4 * M3x12
4 * M3x6+6
8 * M3 nuts