The R12DS is the flagship receiver from radiolink, capable of 4Km range when coupled with the impressive AT10II R/C radio.  The R12DS is a 12 channel receiver that uses both DSSS and FHSS spread spektrum technology simultaneously to have seriously impressive noise robustness and range.  This R12DS is compatible with all variants of the AT9 and AT10 series radios.  This receiver is also fully compatible with MAVlink telemetry via the PRM-1 or PRM-2 modules giving you the ability to view your aircraft telemetry on your radiolink AT9 or AT10 screen.  Another unique feature of this radio is that you can  SBUS our PWM outputs work at the same time, so you can choose to use CH1-6 via SBUS, and CH 7-12 via PWM which opens up a world of possibilities for interesting applications.  The amount of PWM channels you can use simultaneously depends on how many SBUS channels are using.

Note: looking a the smaller version? Check out our R12DSM 12CH Receiver. 

Key Features

• 12 Channel Receiver with diversity antennas
• Capable of 4Km range with AT10II radio
• Simultaneous use of DSSS and FHSS technology for impressive signal range and robustness
• Ability to output SBUS and PWM signals at the same time
• Compatible with all AT9 and AT10 series radios
• 4096 section precision, 0.25us per section
• Compatible with PRM modules for MAVlink telemetry
• Firmware upgrade

SBUS working mode

PWM only working mode

How to bind R12DS to your Radiolink radio

• Put the transmitter and the receiver close to each other within 1 meters.

• Turn on the transmitter

• Connect CH3 of R12DS to a 5V power supply (such as an ESC with BEC output) to turn on the R12DS.

• There is a black button on the R12DS, use a thin stick press the button twice in two seconds, receiver light starts blinking, after a short time (about 8 blink cycles), the receiver with match code with the radio

• You have successfully bound your radio and receiver.  The receiver signal LED always on when connected to your radio!

Specifications

1) Channels: 12 channels: output 12 channels signal, support S-BUS and PWM signal output synchronously.

2) Working voltage: 4.8-10V

3) Working current: 38-45mA（input voltage: 5V）

4) Size: 50*31.5*14.5 MM

5) Weight: 14g

6) Receiver integrate telemetry sensor including signal strength and voltage. Support extended engine voltage telemetry module PRM-01 and module PRM-02 can feedback GPS info, Speed, voltage etc. on AT9/AT9S/AT10/AT10II display when work with flight controller APM or PIX.

7) 4096 section precision, 0.25us per section, servo anti-shake rudder.

8)Control distance: about 4 kilometres air (Maximum range tested in unobstructed areas free of interference and may vary depending on local regulations).