iFlight SucceX 20mm Mini F4 TwinG Tower V3 + 35A 4in1 ESC (Optional VTX)

The SucceX Mini F4 V3 TwinG // GYRO FUSION is the NEXT-GEN flight controller you need for your next build. This FC is ready for anything with 4 uarts With its clean intuitive layout, the SucceX MINI F4 V3 TwinG makes installation a breeze with 10 pin connector that allows simple plug and play connection with your 4in1 ESC and optional SucceX 500mW VTX.

But the real magic of this flight controller lies in its TWIN GYRO configuration.

The TwinG uses two identical gyros oriented side by side with one offset 90 degrees from the other. Betaflight uses GYRO FUSION to blend and average the information from both gyros to send a much cleaner signal to the PID loop controller! Less noise and fewer oscillations across the throttle band without adding any delay! Betaflight software filters can be lowered in most cases as well, which brings a significant decrease in delay.

With plenty of processing power and uarts, this is the perfect flight controller for long-range GPS builds. And the TwinG configuration makes it the perfect Fc for builds like macro quads, cinematic filming rigs and x-class racers that are a bit trickier to tune.

Connection Guide

FC // SucceX Mini F4 V3

• MCU: 168MHz STM32F405
• Gyro：2x ICM20689
• Blackbox：32MB
• Betaflight OSD: YES
• BEC: 5V 2.5A
• Current sensor scale:  100
• Inverter for SBUS input (UART2-RX)
• Smartaudio & Tramp VTX protocol supported
• Beeper pad : Yes
• RSSI input pad: No

• UARTs：4
• BLHeli32 Telemetry：RX6
• Input voltage：recommended 2-6S, MAX 8S
• Target:   STM32F405 (CLI config necessary; Check SETUP GUIDE above)
• Mounting pattern: 20*20mm φ3
• Dimensions:   27*27mm

ESC // SucceX Mini 35A V3

• MCU: STM32F051K66
• Up tp 48kHz PWM frequency
• Capacity: 220uf/35V uF
• Current Sensor: Yes
• Input: 2-6s lipo
• Constant: 35A / Burst: 40A
• BlHeli32 telemetry: Yes
• Supports up to Dshot1200, Proshot, Oneshot, Multishot
• Target: iFlight-BL32-4IN1
• Weight:16.7g
• Mounting pattern: 20*20mm φ3
• Dimensions: 31*31mm(including the power pads)