100mW Ardupilot Unmanned Telemetry Kit V3 (433MHz)

This is the 100mW Unmanned Tech produced 433mhz telemetry kit (V2) that is based on the 3DR Telemetry kit and is 100% compatible as it runs the same firmware on-board. This firmware used by 3D Robotics is completely open-source which is, of course, the reason we are able to use it on our own version at Unmanned Tech. The Unmanned Telemetry Kit is compatible with Ardupilot or Pixhawk-based systems and allows you to easily add a two-way telemetry connection between your drone and ground station. This product comes with our full support and warranty as we are confident in the functionality and reliability of this item.

This is the new and improved V2 of the Unmanned Telemetry kit. The full features and specifications are listed below but the main features are that both air and ground module are now interchangeable, and each is with a USB connector and a DF13 connector. The kit also now includes an OTG cable and cables to allow you to connect to APM and Pixhawk. Please note that to connect to Pixhawk, it is a good idea to also purchase a 6-pos to 6-pos cable as this is easier and better than using the cable included.

433Mhz Unmanned Telemetry kit V3 Features and Specifications:

• Interchangeable air and ground modules
• 433 mHz
• Micro-USB port
• 6-position DF13 connector
• 100 mW maximum output power (adjustable)
• -117 dBm receive sensitivity
• Based on HopeRF’s HM-TRP module
• RP-SMA connector
• 2-way full-duplex communication through adaptive TDM
• UART interface
• Transparent serial link
• MAVLink protocol framing
• Frequency Hopping Spread Spectrum (FHSS)
• Configurable duty cycle
• Error correction corrects up to 25% of bit errors
• Open-source SIK firmware
• Configurable through Mission Planner and APM Planner
• Supply voltage: 3.7-6 VDC (from USB or DF13 connector)
• Transmit current: 100 mA at 20 dBm
• Receive current: 25 mA
• Serial interface: 3.3 V UART
• 26.7mm x 55.5mm x 13.3mm (without antenna)