Matek F405 AIO F4 Betaflight Flight Control Board with PDB

Matek F405 AIO F4 Betaflight Flight Control Board with PDB and F4 technology supplied with matek rubber mounts.

This is the All-in-one (AIO) F4 FC by Matek, combing a F405 FC and PDB together, built-in BetaFlight OSD, Dual BEC 5V/2A & 9V/2A, SD card slot for Blackbox and current sensor.

Specifications:
Target : MATEKF405
MCU : 168MHz STM32F405
IMU : 32K ICM20602 accelerometer/gyro (SPI)
Max. 32K Gyro update & 16K PID Loop
OSD : BetaFlight OSD w/ AT7456E chip
Blackbox: MicroSD card slot (SD/SDHC)
VCP, UART1, UART2, UART3, UART4, UART5
Built in inverter for SBUS input (UART2-RX)
PPM/UART Shared : UART2-RX
SoftSerial on S5 & S6 optional
Smartaudio & Tramp VTX protocol supported
Spektrum BIND_PIN : RX4
WS2812 Led Strip : Yes
Beeper : Yes
RSSI : Yes
* If Gyro 32kHz & PID loop 16kHz, Blackbox logging rate 1kHz Max.

PDB Specifications:
Input : 9~27V (3~6S LiPo) w/TVS protection
PDB : 4x30A (Max.4x50A), 6 layers*2oz copper PCB
Dual BEC : 5V/2A & 9V/2A
LDO 3.3V : Max.300mA for Spektrum RX
Current Sensor 200A (Scale 165)
Battery Voltage Sensor : 1:10 (Scale 110)
General Specifications
2x LEDs for FC STATUS (Blue, Red)
6x PWM / DShot outputs without conflict
5x UARTs
1x Group of G/S1/S2/S3/S4 pads for 4in1 ESC Signal/GND
4x pairs of corner pads for ESC Signal/GND connections (DSHOT compatible)
1x pair I2C1 pads (for INAV firmware only)
1x Side-press button for BOOT(DFU) mode
36x51mm PCB with 30.5mm mounting holes & XT60 socket
12g