Matek F411 - One Flight Controller

Matek F411 One Flight Controller NEW -  This is the latest all In one FC to come out of MatekSys.

It as a FrSky X Receiver and F411 MCU with built in PDB making this a very popular choice with FPV Drone racers wanting a neat and compact build.

Comes with Vibration Dampners and a capacitor.

Please note these currently only work with D8/D16 International Firmware they will also work with D8 EU LBT if you run the latest version of OpenTX on your transmitter.


Main Features:
Built In Frsky X Type Receiver
3 x Led Status Indicators
4 x PWM DShot Outputs
2 x UARTs
4 x Easy to Solder corner Pads for Escs
2 x Side Buttons for  1 for Bind and 1 for Bootloader


Matek F411-ONE Specifications

• MCU: 100MHz STM32F411CEU6
• IMU: MPU6000 gyro/accelerometer (SPI)
• OSD: BetaFlight OSD w/ AT7456E chip
• SPI RX: module 2500-2431, Frsky_X or Frsky_D protocol
• VCP, UART1, UART2
• WS2812 Led Strip : Yes
• Beeper : Yes
• PPM: RX2 pad
• Blackbox: No
• SBUS input: No
• I2C1 SDA & SCL: No

PDB Specifications

• Input: 6~30V (3~6S LiPo) w/TVS protection
• PDB: 4x30A (Max.4x46A)
• BEC: 5V 2A cont. (Max.3A)
• LDO 3.3V: Max.300mA
• Current Sensor 184A (Scale 179)
• Battery Voltage Sensor: 1:10 (Scale 110)
• 3x LEDs for FC STATUS (Blue) , RX (Green) and 3.3V indicator(Red)
• 4x PWM / DShot outputs
• 2x UARTs
• 1x Group of  G/S1/S2/S3/S4 pads for 4in1 ESC Signal/GND
• 4x pairs of corner pads for ESC Power connections
• 1x Side-press button for BOOT(DFU) mode
• 1x Side-press button for RX bind
• 36x46mm PCB with 30.5mm mounting holes
• 10g
• w/ 1x Rubycon ZLH 35V/470uF (Low ESR)
• w/ 6x silicon grommets M4 to M3
• w/ 2x IPEX- 2.4G antenna 15cm