Rc Parts Catalog, United Kingdom
Contact Us
Home > TBS Tiny LEDs WhitenoiseFPV Unify Mounting Board with Realpit
TBS Tiny LEDs WhitenoiseFPV Unify Mounting Board with Realpit

TBS Tiny LEDs WhitenoiseFPV Unify Mounting Board with Realpit

Product #: 88220
Price:
£8.00 Price drop alert!
Stock:
In Stock
Store:
FlyingTech
 
Products from FlyingTech
Categories:
Reviews:
BUY NOW
Add to Wishlist

FEATURES

  • Plug in your VTx at any time with 0 power start-up (Not Available with FlightOne at current time)
  • Turn off your VTx on the line to avoid heat buildup
  • Fast Team Race Pit stops (Sub second transitions possible)
  • Compatible with TBS Unify Nano, 5v Pro, HV v3 
  • Mounting for Receiver on bottom of board. XM+ or XF easy mount
  • Turn off VTx during races to test hover builds without interfering with other pilots in the air.
  • Turn off VTx after Crash for clean video for other racers. 
  • Solo Endurance Races, 3 quads ready on the line. Practice for more than 1 pack without taking off goggles. (Instructions on how to setup on OpenTX / Spektrum Coming soon)
  • LED Indicator light on board. (Light On Power On)
  • Can be used on any pad on Betaflight Flight Controller. 
  • BUILT-IN capacitors for 5v camera/vtx power and Lipo battery voltage. (Clean up video lines)

CURRENTLY SUPPORTED SOFTWARE

  • Betaflight (PinIO)
  • Butterflight (PinIO)
  • FlightOne 1.2.x+ (VTXPRWTOGGLE)

BetaFlight Settings:

In CLI:

Type RESOURCE

Locate UART TX/RX pad resource ID you are using.  We wired to RX4 in this demo. RX4 is A01  Note the name of resource and ID. 

Next we will clear that pad from its assigned resource.
 
Type 
RESOURCE SERIAL_RX 4 NONE
 
Next we will set the Custom Mode Switches. We will set up 4 switches for up to 4 Realpits. Copy and past these Commands into CLI:
 
set pinio_box = 40,41,42,43 
aux 2 40 2 1600 2100 0
aux 3 41 3 1600 2100 0 
aux 4 42 4 1600 2100 0 
aux 5 43 5 1600 2100 0
 

Next we need to assign the Resource ID to the Custom Mode switch. Using the Resource ID from above. "A01"

resource PINIO 1 A01
 
If you wish to set up more pads for additional RealPits. replace the area in brackets with your resource IDs:

resource PINIO 2 [resource=I.E=A04]
resource PINIO 3 [resource=I.E=A05]
resource PINIO 4 [resource=I.E=A06]

Type  SAVE  in CLI and then press enter. Your FC will reboot after applying changes. 

Now go to Modes and Assign an AUX channel to the USER1 mode. Just like an arm or turtle mode switch. Click SAVE. 

Now flip the switch and test. A RED LED will be lit on RealPit if your are providing power.


Promotion vidoes