Strobon SE V2 - Strobe Light Controller

Strobon SE drives any Power LED with 1000mA for 40ms (2 x 20ms pulses) on every second and this generates very bright flashes with very low power consumption (50mAh).

Strobon SE v2 is completely same circuit design with our revolutionary STROBON v2 Navigation Strobes excluding the LED and size. It is a more flexible design than other LED embedded Strobon models. You can choose any Power LED(1W) and install only the LED body outside of your flying platform. It works with any Power LED(3W) and it also drives more than one Power LED (the colours must be the same for same forward voltage).

Now, it's configurable for 5 different patterns!

• Strobe (Legendary Strobon v1 strobe effect. 3 fast flashes like xenon wing tip flashlights)
• Blink (Simulates belly or tail lights. Continuous ON/OFF)
• Heartbeat (standard beacon light pattern, ramp up/ramp down/off)
• Rotating Beacon (perfect simulation of rolling beacons. ramp up/flash/ramp down/off)
• Static (you can use it as landing headlights or static wing-tip lights)

It allows 2 different working modes, RC mode or Standalone.

• Power it with directly from battery (4-6v) it works on Standalone mode and strobes continuously.
• Plug it on your RC receiver’s any channel for RC mode, then you can On/Off  it over servo channel.

SCHEMATIC for SYNCRONIZED & RC CONTROLLED MODE

SCHEMATIC for STAND ALONE MODE

PATTERN SELECTION

All you need a piece of wire or a tweezer to change the pattern. Connect two small pads of the Strobon SE v2 board while it's working (it will not change the pattern when it's OFF) It will stop working when you connect these pins and jump to next pattern when you release the connection. That's all.

Frequently Question: How many LEDs can it drives?
Answer: There is no limit. The light intensity drops depend led count. Our suggestion is maximum 3-5 units 3W Power LEDs gives acceptable light intensity.