Holybro Tekko32 F3 4-in-1 45A ESC BLheli_32 Dshot 1200 (Revision C)

The latest tekko32 45A 4in1 (Revision C) ESC has got some improvements on its performance:

1) Enhanced BEC, withstand voltage up to 80V.
2) The first blheli32 ESC in the market with default PWM output 96K giving you smoother and quieter experience.
3) Amperage meter scale ratio has been adjusted to 185-195.
4) The mounting hole has been changed into M4 with anti-vibration silicone grommet Insert.
5)The PCB design uses a design in which the drive circuit and the control circuit are separated. This design broadens the overcurrent capability of the drive circuit, and at the same time reduces the electrical interference to the control circuit.

Holybro's Tekko32 45A 4-in-1 ESC features an F3 MCU to give smooth operation and quick response. It supports 45A continuous current and up to 55A burst, making it compatible with most 5-6inch racing drone setups, even up to 6S. The ESC is the 4-in-1 that features in Holybro's new F7 HDV Stack for the DJI HD FPV System; it can also be used with other FCs too. The layout of the PCB is very logical and with large contact pads it's also easy to solder.

For 6S setups please use the included extra low ESR 35V capacitor. This can be attached to the dedicated + / - pads on top of the ESC.

Features:

• F3 MCU runs double faster than F051
• 32bit ESC with BLHELI32 firmware
• 4-in-1 ESC with 30.5x30.5mm mounting holes
• Added more CAPS to reduce power noise
• 3S – 6S LiPo Input
• 45A Continuous Current Rating, 60A Bursts (10 seconds)
• Supports Oneshot / Multishot / Dshot PWM / DSHOT 1200 / Damped light
• Separate current sensors for each motor, Voltage output (VBAT), ESC Telemetry (TELEM)
• No BEC