Gravity 180 FPV Racing Frame - Red

The Gravity 180 FPV Racing frame has been CNC machined to the highest tolerances from four pieces of HDPE. This frame must be one of the toughest racing frames on the market and comes with a Lifetime Frame Warranty*

The Gravity has been designed around specific components to keep the frame as low as possible. Recommended components are as follows: 

• Naze 32 with ESC connections hard wired
• 1806 and 2200 series motors with 4” props
• Little Bee FVT 20A Pro ESC
• CC3D Power Distribution Board or similar (36mmx36mm)
• VTX
• Sony HS1177 FPV Camera

 Other components can be used but Fossils Stuff cannot guarantee they will fit without possible modification to the Mainframe or Top Cover.
 
Main Features:

• FPV camera protection
• Motor protection
• Accessible VTX dip switches from window in Top Cover
• Integrated XT60 connector supplied
• Battery protection
• Motor ventilation holes
• LED rear bumper for 5 programmable LED’s
• Naze 32 Rev 5 and Rev 6 USB access
• Naze 32 pre-drilled mounting holes
• Large airflow slots in motor arms
• Machined channels in arms for motor wires
• Central COG with 4S 1.5 ah lipo battery

The Top Cover can be easily removed and re-fitted with only 4 x M3 screws allowing quick and easy access to the inside.

The Lifetime Frame Warranty* covers any part of the frame that has been damaged badly enough to render the frame un-flyable. The damaged part/s will be replaced on return of the warranty certificate and the damaged part/s. The frames will need to be registered with Fossils Stuff either by email or post for the Warranty to be valid. This warranty is valid for the lifetime of the Mainframe, Battery Tray, Mid Cover  and Top Cover.

Holes may be drilled in Top Cover for VTX antenna and LED wire route at rear of mainframe. No other modifications may be carried out. The carbon fibre tubes and 45mm bolts retaining the battery tray are not covered under the warranty.