mRo Pixracer R15 Kit – Pixracer, Case, 433 Radio, GPS, ACSP5

This Kit Includes;

• 1 x Pixracer R15 and 3D Printed case
• 1 x GPS M8N with LIS3MDL + IST8310
• 1 x wiring cable pack and micro SD card
• 1 x ACSP5 Power module (upto 10s 80A)
• 1 x Pair 433mhz telemetry radios

Product description

[Assembled in California by mRo] [Designed by AUAV.co & mRo, both US based]

mRo with the special collaboration of AUAV.co is proud to announce the PixRacer MultiCoper kit! The cheapest, fastest and genuine way to build your own “drone”.

The kit includes a PixRacer Flight Controller, GPS w/ GLONASS+Compass, 10S Power Module (ACSP5), 915MHz/433MHz Telemetry Radio Pair and all Cables needed.

Many people will mistakenly believe that the PixRacer is just a standard “racer” controller that lacks many of the functionalities of a complete autopilot system. Well, don’t be fooled! PixRacer has all the capabilities of the original PixHawk -including version 2- and even more! But is optimized in size and has just about the right amount of input/outputs that allows you to switch from a full enriched autopilot stack system -with autolanding and full navigation- to a high-performance racing platform. Yup, if you get tired of advanced precision waypoints, then flip the switch and race like a pro!

Specifications:

Microprocessor:
32-bit STM32F427 Cortex M4 core with FPU rev. 3
168 MHz/256 KB RAM/2 MB Flash

External Memory:
F-RAM Cypress MF25V02-G 256-Kbit nonvolatile memory (Flash memory that performs as fast as RAM)
SD Card slot with 8gb Micro SD card SanDisk. Adapter included

Sensors:
Invensense MPU-9250 3-axis accelerometer/gyroscope/magnetometer
MEAS MS5611 barometer
ST LIS3MDL magnetometer

Interfaces:
5x UART (serial ports), one high-power capable, 2x with HW flow control and GPS+I2C®
CAN
Spektrum DSM / DSM2 / DSM-X® Satellite compatible input up to DX9 and above.
Futaba S.BUS® & S.BUS2® compatible input
FRSky Telemetry port output
Graupner SUMD
Yuneec ST24
PPM sum input signal
OneShot PWM output (Configurable)
RSSI (PWM or voltage) input
I2C
SPI
External microUSB port
JTAG
Dronecode Debug connector
WiFi Telemetry & firmware update via ESP8266 (Included!)
6x PWM outputs
JST-GH connectors using Dronecode connector standard

Power System:
Ultra low noise LDO voltage regulators

Weight and Dimensions:
Weight: 10.54g (.37 oz)
Width: 36mm (1.42”)
Length: 36mm (1.42”)